Kadın Sahte Doğal Nude Makyaj Crossover Sert Saplı Kahve Rengi Üst Kirpikler

A box of 5 pairs, length 0.5-1.1CM 001/022 Same style 001 Black 022 Brown A box of 500 boxes, please contact us if needed Prepare tools: Eyelash curler, small scissors (eyebrow or pointed scissors), tweezers, false eyelash glue (transparent or black) preparation: The task of fake eyelashes is to confuse the real with the fake ones, so the focus of preparation work is to achieve consistency between the curvature of one's eyelashes and the fake eyelashes, which can be done with an eyelash curler. Step1: Using a three-stage clip method, use an eyelash curler to clip from the base of the eyelashes to the end, ensuring that the entire eyelash is clamped in place. Be careful not to curl the roots too much, as it will make the false eyelashes difficult to adhere. Step2: Don't use eye black on your own eyelashes, just curl them. Step3： New false eyelashes may leave a small amount of adhesive residue, so be sure to use tweezers to clean them thoroughly. Local adhesion method: The entire false eyelash is difficult to control during operation, and partial pasting can avoid the problem of the entire eyelash curling up at both ends. Step1: Cut the false eyelashes into sections of approximately 5-6 millimeters each. The part near the end of the eye can be slightly longer, and the part near the head of the eye can be slightly shorter for easier operation. Step2： Use flat tipped tweezers to grip the upper part of the false eyelashes, with the tweezers pointing parallel to the base of the false eyelashes. Gently apply a layer of glue without brushing too much. Step3： Apply the adhesive and wait for a few seconds until the adhesion is good. Step4: Starting from the end of the eye, start sticking at a distance of about 2-3 millimeters from the corner of the eye. Hold the tweezers with the thumb up, aim at the position, clamp the eyelashes and gently push them inward. After holding for a few seconds, the eyelashes will stick firmly on. Step5: Then stick the remaining false eyelashes in the direction of the head of the eye for a period of time, and do not need to apply eye black again. Whole set adhesive method: The closer the fake eyelash sticker is to one's real eyelashes, the more it looks. Make the false eyelashes stick to the border between the eyelids and eyelashes. Step1： First, measure the length of the false eyelashes. Align the inner side of the false eyelashes with the inner corner of the eye, 4-5 millimeters behind it. There is no need to cover the inner corner of the eye completely. The overall length should be slightly longer than your own eyes, and the excess part should be cut off. Step2： Pinch the two ends of the false eyelashes and gently push them inward, allowing them to bend appropriately and increase their curvature to fit the eye shape. Step3: Use tweezers to pick up the entire set of false eyelashes, find the center point of the eye, and stick the false eyelashes onto it. First, stick the end of the eye tightly against the base of the eyelashes, and then press the inner corner of the eye as well. Step4： Gently push the eyelashes inward with your fingers to make them fit tightly. Step5: Use a black eyeliner pen to draw the connection of the false eyelashes, thus completing the pasting steps of the false eyelashes.